2008 Terex C5000 Recalls

All 2008 Terex C5000 recalls can be found below. It is important to us to provide a complete resource for recall information, so if you know of any additional related recalls, please contact us to let us know.

March 16th, 2016

NHTSA Campaign Number: 16V154000
Manufacturer: TEREX SOUTH DAKOTA, INC.
Manufacturer Campaign Number: SN636
Manufactured Begin Date: May 5th, 2008
Manufactured End Date: February 26th, 2016
Date of Owner Notification: April 29th, 2016

Defect Summary:
Terex South Dakota, Inc. (Terex) is recalling certain model year 2015-2016 C5000, C6000, General 80, RMX, TM100, and TM125 aerial devices, and digger derrick lifts installed on trucks manufactured August 4, 2015, to February 16, 2016. The suspension circuit can inflate the suspension air bags on the affected vehicles if the Master/PTO switch or ignition is turned off in the cab while the boom is in the raised position. This can cause the frame to rise, lifting the outriggers from the ground.

Consequence Summary:
If the outrigger lifts off the ground, causing instability of the truck, it can increase the risk of injury to the operator.

Corrective Summary:
Terex will notify owners, and dealers will install a second outrigger enable relay, free of charge. The recall began on April 29, 2016. Owners may contact Terex customer service at 1-800-982-8975. Terex's number for this recall is SN636.

Recall Notes:
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

May 4th, 2009

NHTSA Campaign Number: 09V149000
Manufacturer: TEREX SOUTH DAKOTA, INC.
Manufacturer Campaign Number: CB584
Manufactured Begin Date: September 11th, 2008
Manufactured End Date: December 20th, 2008
Date of Owner Notification: July 31st, 2009

Defect Summary:
TEREX TELELECT, INC. IS RECALLING 142 MY 2008 C4000, C5000, C6000, C7000, AND GENERAL DIGGER DERRICK UTILITY TRUCKS MANUFACTURED BETWEEN SEPTEMBER 11 AND DECEMBER 20, 2008, EQUIPPED WITH EATON 25VQ HYDRAULIC PUMPS. POOR ADHESION OF THE BRONZE MATERIAL AND THE STEEL SURFACE OF THE FLEX PLATE USED IN THE 25VQ SECTION MAY LEAD TO DELAMINATION OF THE BRONZE FROM THE PLATE.

Consequence Summary:
FAILURE OF THE PUMP WILL MAKE THE UNIT INOPERABLE AND POSSIBLY LEAVE THE OPERATOR OR LOAD SUSPENDED WHICH COULD RESULT IN PERSONAL INJURY OR DEATH.

Corrective Summary:
TEREX WILL NOTIFY OWNERS AND REPAIR THE VEHICLES FREE OF CHARGE. THE RECALL BEGAN ON JULY 31, 2009. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT AT 1-605-884-3892.

Recall Notes:
TEREX'S RECALL NO. CB584.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV .

Recall Comments

No comments have been posted.
Be the first to add a comment!