2011 Altec Digger Derrick Recalls

All 2011 Altec Digger Derrick recalls can be found below. It is important to us to provide a complete resource for recall information, so if you know of any additional related recalls, please contact us to let us know.

August 15th, 2014

NHTSA Campaign Number: 14V503000
Manufacturer: ALTEC INDUSTRIES INC.
Manufacturer Campaign Number: CSN 603
Date of Owner Notification: October 15th, 2014

Defect Summary:
Altec Industries, Inc. (Altec) is recalling certain model year 2000-2013 Aerial Device and Digger Derrick trucks, equipped with Sure Power Battery Equalizers containing a particular epoxy sealing, aka 'potting', compound. The specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat.

Consequence Summary:
Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.

Corrective Summary:
Altec will notify owners, and dealers will replace any affected battery equalizer, free of charge. The recall is expected to begin in September 2014. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 603.

Recall Notes:
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

December 24th, 2013

NHTSA Campaign Number: 13V636000
Manufacturer: ALTEC INDUSTRIES INC.
Manufacturer Campaign Number: CSN 591
Manufactured Begin Date: June 1st, 2009
Manufactured End Date: November 30th, 2013
Date of Owner Notification: February 19th, 2014

Defect Summary:
Altec Industries Inc. (Altec) is recalling certain model year 2009-2013 DT80, and model year 2011-2013 D2, D3 and D4 digger derrick models manufactured June 2009 through November 2013. The fasteners that hold the bracket for the feeder tube (the telescopic hydraulic tube that supplies pump flow to the auger) may become loose allowing the feeder tube to fall.

Consequence Summary:
A falling feeder tube increases the risk of injury to people nearby.

Corrective Summary:
Altec will notify owners, and Altec service centers will install an upgraded feeder tube bracket and mounting hardware, free of charge. The recall began on February 19, 2014. Owners may contact Altec at 1-877-462-5832. Altec's number for this recall is CSN 591.

Recall Notes:
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

April 15th, 2013

NHTSA Campaign Number: 13V141000
Manufacturer: ALTEC INDUSTRIES INC.
Manufacturer Campaign Number: CSN 574
Date of Owner Notification: June 10th, 2013

Defect Summary:
Altec Industries, Inc (Altec) is recalling certain model year 2007-2012 DC, and DL/DM Digger Derrick utility trucks, equipped with boom tip winches using Tulsa Winch Group (formerly Gear Products) winch drums. In the affected vehicles, the winch drum could deform or fracture.

Consequence Summary:
If the winch fails while in use, it could cause personal injury.

Corrective Summary:
Altec will notify owners and dealers will replace the winch drum, free of charge. The recall began on June 10, 2013. Altec's recall campaign number is CSN 574.

Recall Notes:
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

August 31st, 2012

NHTSA Campaign Number: 12V423000
Manufacturer: ALTEC INDUSTRIES INC.
Manufacturer Campaign Number: CSN 568
Date of Owner Notification: October 12th, 2012

Defect Summary:
Altec Industries, Inc. is recalling certain model year 2011-2012 Digger Derrick vehicles equipped with a PENGO digger extension shaft. A defect in the base material at the weld joint may result in a stress fracture through the applied weld of the drive hub to the hex bar material.

Consequence Summary:
The stress fracture could cause the extension shaft to separate from the drive hub when digging, increasing the risk of personal injury and/or property damage.

Corrective Summary:
Altec will notify owners, and will inspect the PENGO digger extension shaft and, as necessary, replace the shaft, free of charge. The safety recall began on October 12, 2012. Owners may contact Altec Industries at 1-877-462-5832.

Recall Notes:
Altec's recall campaign number is CSN 568.Customers may contact the National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY: 1-800-424-9153); or go to http://www.safercar.gov.

December 28th, 2011

NHTSA Campaign Number: 11V600000
Manufacturer: ALTEC INDUSTRIES INC.
Manufacturer Campaign Number: CSN 554
Date of Owner Notification: January 11th, 2012

Defect Summary:
ALTEC IS RECALLING CERTAIN MODEL YEAR 2008 THROUGH 2011 UTILITY VEHICLES EQUIPPED WITH SURE POWER BATTERY SEPARATOR DEVICES, PART NUMBER 16511893 (MODEL 1314) OR 16512967 (MODEL 1315). THE BATTERY SEPARATOR CAN OVERHEAT.

Consequence Summary:
OVERHEATING OF THE BATTERY SEPARATOR CAN RESULT IN SMOKE AND POSSIBLE FIRE.

Corrective Summary:
ALTEC WILL NOTIFY OWNERS AND REPLACE THE BATTER SEPARATORS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 11, 2012. OWNERS MAY CONTACT ALTEC AT 1-877-462-5832.

Recall Notes:
ALTEC'S RECALL CAMPAIGN NUMBER IS CSN 554.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV .

September 2nd, 2011

NHTSA Campaign Number: 11V451000
Manufacturer: ALTEC INDUSTRIES INC.
Manufacturer Campaign Number: CSN 550
Manufactured Begin Date: January 1st, 2011
Manufactured End Date: April 30th, 2011
Date of Owner Notification: September 7th, 2011

Defect Summary:
ALTEC IS RECALLING CERTAIN MODEL YEAR 2011 DL/DM SERIES, D4000A, AND DB37 DIGGER DERRICK SERVICE UTILITY VEHICLES MANUFACTURED FROM JANUARY 2011 THROUGH APRIL 2011, EQUIPPED WITH PQ SINGLE AXIS BOOM CONTROLLERS. THE MECHANICAL INTERLOCK (LOCK OUT) MAY NOT OPERATE PROPERLY.

Consequence Summary:
IF THE CONTROL INTERLOCK DOES NOT FUNCTION PROPERLY, THE CONTROL HANDLE CAN BE ACCIDENTLY SHIFTED CAUSING MOVEMENT OF THE UNIT, POSSIBLY RESULTING IN SERIOUS INJURY OR DEATH.

Corrective Summary:
ALTEC WILL NOTIFY OWNERS, AND ALTEC DEALERS WILL REPLACE THE HAND CONTROLLERS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON SEPTEMBER 7, 2011. OWNERS MAY CONTACT ALTEC AT 1-877-GO-ALTEC (1-877-462-5832) FOR MORE INFORMATION.

Recall Notes:
ALTEC'S RECALL CAMPAIGN NUMBER IS CNS 550.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV .

Recall Comments

No comments have been posted.
Be the first to add a comment!